The Tire Pressure Monitoring System, TPMS, plays a fundamental role in your vehicle since proper tire inflation and pressure translate to a safer drive as well as give a holistic effect on your vehicle. It is therefore advisable to know where it is located for when you might need to use it.
When it comes to the Nissan Versa, the TPMS reset button is beneath the steering wheel. However, if you have any difficulty locating it, you can refer to the owner’s manual and it will direct you to its exact location. To operate it, the ignition should be turned to the ON position and the engine should be off. Then, hold the button until the TPMS light flashes thrice.
This article sheds some light on the importance of the TPMS button, its location, and its operation so you can have a better understanding of the same. Read on.
Where Is the TPMS Reset Button Located on Nissan Versa?
The tire pressure monitoring system is there to inform the driver that the tires are running low on pressure and need to be inflated as soon as possible.
However, if you notice the light still flashing even after inflating your tires, it could mean that the sensor is malfunctioning, the battery charging system is low, or you need to reset it. You can have this checked when servicing your vehicle, however, more often than not, you are only required to reset this light.
Fortunately, Nissan Versa comes with a reset button for this purpose. You can find this button somewhere beneath the steering wheel. If you are unable to locate it, you should refer to the owner’s manual for its exact location.
How Do You Reset the Low Tire Pressure Light on a Nissan Versa?
Sometimes even if you inflate your tires, you may notice that the TPMS light is still on. If the tire pressure light keeps flashing even after you have inflated your tires simply means that you need to reset it.
There are different ways to go about this, but luckily for Nissan Versa owners, there is a TPMS reset button to solve this problem for you.
As earlier mentioned, the TPMS reset button is often located beneath the steering wheel. If you cannot find it, the owner’s manual is likely to provide more information regarding its location. To operate this, turn your keys on the ignition to the ON position.
Ensure the engine remains off. Then, hold this reset button until you notice the TPMS light flash thrice and release the button. Start your car normally, and after 20 minutes of driving, the light should go off.
How Do You Reset TPMS Without a Reset Button?
If, for any reason, you wish to reset the TPMS without the reset button, there are several ways to do so.
Over Inflate the Tires
An alternative to the reset button is to inflate your tires to 3 PSI above the recommended pressure. Then, completely deflate them before you re-inflate them with normal levels. Ensure you do the same to your spare tire that has a TPMS system on it. This should reset the light.
Disconnect the Positive Cable
The aim of disconnecting the positive cable is to discharge any built-up electrical charges in the system. You can use a wrench for this and then honk the horn for about three seconds to reconnect the battery.
Reset Through Driving
It is possible to reset the flashing light while you are driving. You are required to be driving at no less than 50mph for around 10 minutes. After some time has lapsed, turn off the car and then on again. The light should go off.
What Causes Tires to Lose Pressure?
Typically, tires losing pressure can be attributed to two main reasons: a small puncture or leak or a sudden decrease in temperature.
When the surrounding temperatures drop, the air gets dense and takes up less space. This means that there is reduced pressure from the air in your tires. Also, the light will go on if there is a puncture that is likely to lead to a flat.
If you top off the tire in question can get you to a service center. However, if you have more miles to cover, you might consider installing your spare.
FAQs
Final Thoughts
Of all the dashboard warning lights that could be flashing, you should never ignore the TPMS light. The main purpose of the tire pressure light is to alert you to a problem with your tires.
Therefore, the TPMS is an important safety feature so you should always ensure that it is activated and working properly. This article explains the different ways you can apply to reset it when necessary.
Related Posts:
